Cork Clean UV Wash CORK-CLEAN™ is an aqueous, blanket and roller wash for UV coatings. It greatly reduces the odor, toxicity, and flammability hazards associated with solvent-based UV washes.CORK-CLEAN™ is designed specifically for use with Cork Industries' GREEN20™ and GREENSOFT™ products, but it works as a blanket and roller wash for all commercial UV coatings.Use this product for coater, anilox, and roller cleanup. Features: Nonflammable Concentrated Low odor Benefits: Concentrated product may be used neat or cut 50:50 with water. Will not contaminate Cork Industries' Green-Series UV/EB coatings. Improved work environment. Cleaning Better Than Conventional UV WashConventional UV wash products are solvent based, they have low flash points (e.g., 145°F), and they have a very high VOC content—50% to 78% or greater. The high flammability of conventional UV wash products makes clean up the most hazardous job for a UV printer. Solvent-based UV washes leave a residue because they dissolve the UV coating. The thin solvent film evaporates and leaves some dissolved UV on the surface just cleaned! Cork Clean is the Smarter, Safer UV Wash Cork-Clean™ is an aqueous, blanket and roller wash for UV coatings. It greatly reduces the odor, toxicity, and flammability hazards associated with solvent-based UV washes. Cork-Clean™ was designed specifically for use with Cork Industries' Green20™, Low Carbon Footprint (LCF), and GreenSoft™ products, but it works as a blanket and roller wash for all commercial UV coatings. How it Works Cork-Clean™ is an aqueous-based product which reacts with a UV coating. The reaction makes the UV coating dispersible in Cork-Clean™ and serves to take the UV coating from rubber rolls and out of anilox cells cleanly. The wash then rinses off with no residue. Cork-Clean™ is safe for butyl rubber and all typical elastomeric rollers. Instructions for Cleaning UV Ink Rollers: Apply Cork-Clean™ to rollers. Allow 20 to 30 seconds to penetrate. Apply more Cork-Clean™ as needed until rollers are ink free. When ink free, rinse or wipe thoroughly with tap water. DO NOT rinse or wipe with water until roller is ink free. Dry water with clean rag. Note: Your initial clean up may take longer than normal as Cork-Clean™ will release embedded ink pigments from rollers. After repeated applications, your rollers will return to a near-original condition. Prev Next